Step three:

Go to Select > Load selection > Default to select the entire case. Cut out a similar shape from the picture guide.

Create a new layer and fill selection with #000000.

Go to Filter > Blur > Motion Blur > Angle: 0 || 10 px.

Cut out the extra blur outside the case by select the case layer from the layer panel then Go to Select > Load section > Default. Again Go to Select > Inverse to reverse the selection from the case to the background. Once the selection is pointing outside, go back to the new layer you just made and go to Edit > Cut.

Create a new layer behind the case. Select the round rectangle tool and set the radius to 20px. Draw a #000000 rectangle behind the case.

Note: The purple case on the picture guide is there to show you the space between the case and this new rectangle your going to draw.



Step four:

Now were going to add details on that rectangle you just added, select the Pen tool and turn on paths.

Create a new layer.

First were going to brush the bottom left edge of the case, use the pen tool to draw an arc type shape. Once you have the paths connected, make it a selection by clicking on your right mouse and selecting make selection.

Select a large soft brush, set the foreground color to #FFFFFF and brush the sharp tip. Make sure the color fades.



Step five:

Do the same for the top left edge.

Once you finish adding detail on the edge, add the logo on the middle, since I couldnt find a logo of Sun disk anywhere, SunDisk typed in Eras Light ITC font, Sharp and #FFFFFF is fine.